When running the canned drill cycle gcode the machine would either drill the first point, then rapid move to all of the rest of the points in sequence without running any Z-Axis travel (no drilling), or it would drill the first point over and over again however many times there were points then “finish” the program. It was pretty amusing to watch the controller not know what to do with the posted gcode prior to making those setting changes. The Buildbotics controller DOES NOT support canned drilling cycles, so you will have to disable all of the Canned cycle options in your machined definition/configuration in order for the posted Gcode to be in long hand mode for drilling cycles.
As a follow-up to the previous post I did have to modify the machine definition in order to get drill operations to post correctly.
0 kommentar(er)
